Manual

ManualsBrandsStar Water Systems ManualsAccessories for waterS07AF10 Filter

INSTALLATION INFORMATION

Model No. ______________________________________

Unit Date Code __________________________________

Date Installed ____________________________________

WATER ANALYSIS RECORD

Hardness _____ GPG Sulfur _____ PPM

Iron _____ PPM pH _____

Manganese _____ PPM Tannins _____ PPM

Turbidity _____ FTU

Other:

Other Water Treatment Equipment Installed:

Installed By:

For Service Call:

AUTOMATIC MODELS

07AF-10

134841

95 North Oak Street • Kendallville, IN 46755

SW0015

0310

Supersedes

0201

INSTALLATION INSTRUCTIONS

Fully Automatic Water Filters

Summary of content (5 pages)

PAGE 1
SW0015 INSTALLATION INSTRUCTIONS 0310 Supersedes 0201 Fully Automatic Water Filters INSTALLATION INFORMATION Model No.
PAGE 2
WATER FILTER SPECIFICATIONS (Figure 1) APPLICATION FILTER BED Neutralizing Acid Water, 6.0 to 7.0 pH 1 cu. ft. Neutralizing Mineral and 20 lbs.* “D” Gravel (Underbed) Taste and Odor Removal, Wide Application 1 cu. ft. Activated Carbon and 20 lbs.* “D” Gravel (Underbed) Remove up to 10 PPM Iron 1 cu. ft. Birm and 20 lbs.* “D” Gravel (Underbed) Remove fine suspended matter and turbidity up to 125 PPM 1 cu. ft. Filter-Ag and 20 lbs.
PAGE 3
FILTER INSTRUCTIONS 2. LOCATION These instructions cover fully automatic filters. Read thoroughly before proceeding with the installation. Check to be sure water is available in sufficient volume and pressure to adequately backwash the equipment at the specified rate. When higher service flow rates are required or water for backwash is limited, two units should be installed in parallel. Such an installation doubles the service flow rate without increasing the backwash requirement.
PAGE 4
. WATER SUPPLY CONNECTIONS Figure 2 shows typical installations. Inlet and outlet connections are 3/4 inch pipe size and are marked with raised arrows on the sides of the plastic valve. Turn off main water supply and connect the pipes, valves and fittings. CAUTION: IF COPPER PIPING WITH SWEAT FITTINGS IS USED, DO NOT SWEAT DIRECTLY INTO THE IN/OUT MANIFOLD OF FILTER VALVE OR BY-PASS VALVE. HEAT WILL DAMAGE RUBBER AND PLASTIC PARTS. AUTOMATIC CONTROL VALVE 5. DRAIN LINE CONNECTIONS 7.
PAGE 5
9. STARTING THE UNIT 13. FINAL CHECKOUT Place the control valve in the SERVICE POSITION and follow these steps: (a) B e certain by-pass valve is closed and inlet and outlet valves are fully open. (a) P lace the by-pass valve (valves) to SERVICE position and allow water to flow into the mineral tank. On a 3-valve system (Figure 2) open the inlet and outlet valves and close the by-pass valve. (b) C heck electrical supply to be certain cord is connected to an uninterrupted 115 volt outlet.