Star Trac Instinct™ Shoulder Press OWNER’S MANUAL STAR TRAC 14410 Myford Road Irvine, California 92606 Telephone: (800) 228-6635, (714) 669-1660 Fax: (714) 508-3303 http://www.startrac.com email: support @startrac.
TABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . About This Manual . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 4 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
18 STAR TRAC INSTINCT SHOULDER PRESS OWNER’S MANUAL STAR TRAC INSTINCT SHOULDER PRESS OWNER’S MANUAL 3
INTRODUCTION Thank you for choosing the STAR TRAC INSTINCT SHOULDER PRESS. This unit has been designed to provide the user the most rewarding experience based upon the carefully planned features it possesses. The design elements of this product will provide you with a comfortable, intuitive, safe and reliable experience, guiding you to a habit-forming lifestyle.
WARRANTY & DISCLAIMER SAFETY INSTRUCTIONS STAR TRAC warrants all frameworks for a period of 10 years. All moving parts are warranted for 1 year. 10 year limited warranty on structural frame not including coatings. 90 days on upholstery stitching only, cables and belts. Warranty is for parts only. Warranty is good and available to the original purchaser only as noted by STAR TRAC invoice and is not transferable nor assumable.
ASSEMBLY AND SETUP LABELS AND PLACARDS PARTS AND MATERIALS The following parts are included with the STAR TRAC INSTINCT SHOULDER PRESS 1 2 3 5 6 9 10 11 13 14 15 16 25 26 27 28 29 Frame, Weight Stack Crossbeam, Upper Frame, Main Leverage Arm Crossbeam, Lower Shroud, Lower, Front Plate, Top, Weight Stack Selector Pin Shaft, Leverage Arm Guide Post, Weight Stack End Cap Weight, 10lb Cushion, Seat Cushion, Back Shroud, Lower, Rear Shroud, Upper Support, Weight Stack 1 1 1 1 1 1 1 1 1 2 2 3 1 1 1 2 2 31 32
WEIGHT BELT INSPECTION REQUIREMENTS WARNING: REPLACE WORN WEIGHT BELTS IMMEDIATELY. FAILURE TO COMPLY CAN RESULT IN HAZARDOUS CONDITIONS FOR USERS OR OTHER BYSTANDERS. Inspect all weight belts for evidence of excessive wear or other damage. Give particular attention to the following conditions: ■ ■ Torn or cracked belt Exposed belt cords ASSEMBLY 1.
MAINTENANCE PROCEDURES 3. Assemble the Weight Stack NOTE: Two people are required to assemble the weight stack; one to hold the weight stack guide posts in position, and one to assemble the weight stack components onto the posts. Slide one weight stack support (29) onto each weight stack guide post (14). Insert the weight stack guide posts (14) into the retaining holes in the base of the weight stack frame (1).
While holding the free end of the belt, press down on the opposite side of the belt so it lays flat against the inside of the clamp. CAUTION: Do not "high pin" and/or "double pin" a weight stack. This action is considered to be dangerous to users, and bystanders, and may damage your INSTINCT SHOULDER PRESS. Aside from the mechanical damage that may result, such action(s), in part, may cause the weight stack to crush or pinch fingers, hands and/or extremities.
ANCHORING 40 52 28 52 IMPORTANT: The INSTINCT SHOULDER PRESS must be secured to the floor to stabilize and eliminate rocking or tipping over. This must be performed by a licensed contractor. Failure to anchor the unit will void the warranty. STAR TRAC shall not be liable for damage or injury caused by unanchored or improperly anchored units. 40 34 34 52 34 6.
