Fitness Electronics User's Manual

STAR TRAC UNIVERSAL TV BRACKET INSTALLATION
7
INSTALLING YOUR UNIVERSAL TV BRACKET KIT
The Star Trac Universal PVS Kit is different for each of your Star Trac E or S Series Cardio products. Make sure you have the
proper kit for the E or S Series product you are installing. The E- & S-UB, E- & S-RB, E- & S-TBT, and E- & S-ST will follow
the same basic steps for installation.
To install the TV neck on the E-UB, E-RB, and E-TBT, and follow these steps:
STEP1
Using a #2 Phillips screwdriver, to remove the (8)
screws on the back of the display plastic. Set the
screws aside, you will need them for reassembly.
STEP2
After the screws have been removed, carefully open
the display plastic, so as to not detach the inner
cables from the display.
Disconnect the ground wire between the
Heart Rate board and the display mount.
STEP3
Disconnect the 12-pin serial connector and the
Heart Rate cable from the display.
After all the cable/harnessing has been
disconnected, place the front display plastics
aside for later use. Be careful with the display and
place it face down on top of a non-scratching
surface.