Dot Matrix Printer User's Manual

I
INTERFACE CONVERTER (SPC-8K)
To run the printer in serial mode. you should use the optional Serial/Parallel
Converter (SPC-8K).
The procedure to install the Converter is:
1.
7
-.
3.
4.
5.
[
L
SettheDIP switches on theSPC-8K beforeattaching ittotheprinter. (See
next page for detailed information.)
Turn off the power switch and disconnect the power cord from the power
source.
Disconnect the interface cable if attached.
Connect the Parallel connector to the printer.
Move both c1ips insidethe extended prongs on the sides of the plug until
you hear a click.
Figure 7-21. Connect the Parallel connector to the printer
6. Connect the Serial connector to your computer.
NOTE: Place the Converter on a table in order not to damage the cable.
...
, ~
K
zy2 ,“
+’”
//
,,/
“r
\..-
/
I ;’
t
Figure 7-22. Place the converter on a table.
78