Printer User Manual

Ifthepaperparkfacilitydoesnotappearto be workingcorrectly,checkthe
following:
Check
Possible remedy
Is the paperrelease lever in
The paperrelease lever must be set to the ~ position
the ~ position?
afterthe fanfoldpaperhasbeenparked.
Has the fanfold paperbeen
Makestrrethatthe
PAPERindicatorcomes on afterthe
WWIY puked?
fanfoldpaperhasbeenparked.
If theshorttear-offfunctiondoesnotappearto beworkingproperly,check:
Check
Possible remedy
Has printing ended in the EithersendacFF>orenough <LF>ccmunandstoeject
middleof apage? thepage.
If text is being printed all on one line, or with extra blank lines, check the
following:
I Check ] Possible remedv
Is the text all on the same
tine?
Is text being printed with
extrablanklines?
Carriage returns are not being expanded to
-&R>+cLF>pairs. ChecktheMemorySwitchSetting
andcorrect.
Two line feeds are being printed.Eithermake your
softwareprintjust a carriagereturnor (if this is not
possible), set theAUTOLFtoOFFusingtheMemory
Switch menus.
Ifthepagelengthandmarginsarenotwhatisexpected,checkthefollowing:
Check
Is the printing starting too
highortoo low on thepage?
Does the printer’s page
lengthnotmatchthephysical
page length?
Is the Skip-overperforation
facility not working?
Possibleremedy
Use theMicroFeed facility to adjusttheprintposition
relative to the wwze.
Use the MemorySwitch settings, or the DIP switch to
set up the correct page lengti or use software cOm-
mandsto do it.
Makesure@isis set withtheMemorySwitchmenus.If
theskip occursin thewrongplace, makesurethepage
length is properly se~ and that the top of the print
position is abouttwo lines down from the top of the
uaver.
74