Printer User Manual
Table Of Contents
- Contents
- 1. Printer Setup
- Choosing a place for the printer
- Unpacking the printer
- Printer Components
- Installing the paper guide
- Opening the printer cover
- Removing the printer cover
- Connecting the Power Cord and turning the power ON and OFF
- Installing the ribbon cassette
- Removing the ribbon cassette
- Connecting to your computer using the parallel cable
- Ferrite Core Installation
- 2. Paper Handling
- Selecting paper types
- Cut-sheet paper
- Fanfold paper
- Loading cut-sheet paper
- Printing on cut-sheet paper
- Loading fanfold paper
- Printing on fanfold paper
- Parking fanfold paper
- Unparking fanfold paper
- 3. Control Panel Operations
- Switching between on-line and off-line
- Control panel functions in on-line mode
- Control panel functions in off-line mode
- 4. Using the EDS Mode
- About EDS Mode settings
- Entering the EDS Mode
- Selecting a EDS number
- Selecting a bank
- Selecting a switch
- Changing a switch setting
- Printing the current EDS settings
- Exiting the EDS Modes
- 5. Control Codes List
- < ESC/P-K mode>
- 6. Troubleshooting
- Short test
- Long test
- Hexadecimal dump
- Adjusting the dot alignment
- Troubleshooting guide
– 66 –
ENGLISH
Appendix C. Control Panel Operation Guide
Print mode
: Push
: Hold
ON-LINE
Panel lock (Print mode)
Panel Macro (Print mode & Panel Lock)
Tear off (Page)
OFF-LINE
Set / Park / Eject Line Feed ON-LINE
< Micro Paper Feed >
Hex dump mode Self test (Long) Self test (Short)
BANK SW
ON / OFF
Left Right
Next
Reverse feed Forward feed
Paper loading
Set top of form (TOF)
DOT ADJUSTMENT MODE
AUTO LOADING POSITION CHANGE MODE
Form Feed
Previous
Factory settings & Exit
EDS MODE
Print
Buffer clear (1 Beep) / All reset (3 Beeps)
Exit
Exit
Save & Exit
EDS No.
Reverse
Forward
OFF-LINE
POWER-ON
EDS MODE
DOT ADJUSTMENT MODE
AUTO LOADING POSITION CHANGE MODE
POWER
ON LINE
SET/PARK
EJECT
LINE FEED
FORM FEED
MICRO FEED
TEAR OFF
P.E.