Printer User Manual
Table Of Contents
- Contents
- 1. Printer Setup
- Choosing a place for the printer
- Unpacking the printer
- Printer Components
- Installing the paper guide
- Opening the printer cover
- Removing the printer cover
- Connecting the Power Cord and turning the power ON and OFF
- Installing the ribbon cassette
- Removing the ribbon cassette
- Connecting to your computer using the parallel cable
- Ferrite Core Installation
- 2. Paper Handling
- Selecting paper types
- Cut-sheet paper
- Fanfold paper
- Loading cut-sheet paper
- Printing on cut-sheet paper
- Loading fanfold paper
- Printing on fanfold paper
- Parking fanfold paper
- Unparking fanfold paper
- 3. Control Panel Operations
- Switching between on-line and off-line
- Control panel functions in on-line mode
- Control panel functions in off-line mode
- 4. Using the EDS Mode
- About EDS Mode settings
- Entering the EDS Mode
- Selecting a EDS number
- Selecting a bank
- Selecting a switch
- Changing a switch setting
- Printing the current EDS settings
- Exiting the EDS Modes
- 5. Control Codes List
- < ESC/P-K mode>
- 6. Troubleshooting
- Short test
- Long test
- Hexadecimal dump
- Adjusting the dot alignment
- Troubleshooting guide
– 2 –
ENGLISH
Unpacking the printer
Check that the package contains the following items.
4
5
1
2
3
User
,
s manual
Ribbon cassette
Printer
Paper guide
Ferrite Core
Fastener
If any item is missing, contact the store where you bought the printer and
ask them to supply the missing part. Note that it is a good idea to keep the
original box and all packing materials in case you need to transport the
printer at a later date.
Important!
There are several versions of this printer designed for different
voltages. It is not possible to change the voltage of a printer. If the
voltage shown on the label on the back of your printer does not match
the voltage for your area, contact your dealer immediately.