Printer User Manual

– 50 –
ENGLISH
Printer case is hot. The printer’s air vents are
blocked or obstructed.
Switch off the printer and let it
cool. Check the air vents on
the bottom of the printer to
see if they are blocked.
Remove the obstruction if
possible. If the problem
persists, return the printer to
your dealer for repair.
Printer makes excessive
noise.
The printer cover is removed.
Replace the printer cover.
Printer prints past the edge
of the paper.
Incorrect margin settings are
selected by your application
program.
Choose different margin
settings from your application
program.
The paper edge is not
positioned correctly.
Remove the paper and adjust
the position of the paper
edge. Reload the paper and
try printing again.
The ribbon is jammed,
causing the print head to jam.
Make sure that the ribbon
cassette is installed correctly.
See "Installing the ribbon
cassette" on page 7.
Paper is jamming, causing
the print head to jam.
Remove all paper from the
printer and reload it. Try
printing again.
Set up the printer for the
paper thickness you are using.
See "Adjusting for paper
thickness table" on page 15.
The printer is vibrating.
Move any objects that are
touching the printer.
Make sure that the printer is
on a level steady surface.
Problem Possible Cause Recommended Action