Printer User Manual
Table Of Contents
- Contents
- 1. Printer Setup
- Choosing a place for the printer
- Unpacking the printer
- Printer Components
- Installing the paper guide
- Opening the printer cover
- Removing the printer cover
- Connecting the Power Cord and turning the power ON and OFF
- Installing the ribbon cassette
- Removing the ribbon cassette
- Connecting to your computer using the parallel cable
- Ferrite Core Installation
- 2. Paper Handling
- Selecting paper types
- Cut-sheet paper
- Fanfold paper
- Loading cut-sheet paper
- Printing on cut-sheet paper
- Loading fanfold paper
- Printing on fanfold paper
- Parking fanfold paper
- Unparking fanfold paper
- 3. Control Panel Operations
- Switching between on-line and off-line
- Control panel functions in on-line mode
- Control panel functions in off-line mode
- 4. Using the EDS Mode
- About EDS Mode settings
- Entering the EDS Mode
- Selecting a EDS number
- Selecting a bank
- Selecting a switch
- Changing a switch setting
- Printing the current EDS settings
- Exiting the EDS Modes
- 5. Control Codes List
- < ESC/P-K mode>
- 6. Troubleshooting
- Short test
- Long test
- Hexadecimal dump
- Adjusting the dot alignment
- Troubleshooting guide
– 31 –
Selecting a EDS number
In the EDS Modes , use the control panel’s LINE FEED button, while
holding down SET/PARK/EJECT button to select a EDS number.
When pressed the button, current setting of the bank is printed.
Selecting a bank
While in the EDS Modes , use the control panel’s SET/PARK/EJECT
button to select a bank. When pressed the button, current setting of the
bank is printed.
Selecting a switch
While in the EDS Modes , use the control panel’s LINE FEED button
to select a switch. When pressed the button, current setting of the is
switch printed.
Changing a switch setting
After selecting a bank and a switch, press the control panel’s ON LINE
button to turn the switch on and off. When pressed the button, changed
setting of the switch is printed.
Printing the current EDS settings
While holding down LINE FEED button, press the control panel’s ON
LINE button to print out the current switch settings. Asterisks on the
printout show whether a switch is turned on or off.
Exiting the EDS Modes
While holding down SET/PARK/EJECT button, press the control
panel’s ON LINE button to exit the EDS Modes.