Printer User Manual
Table Of Contents
- Contents
- 1. Printer Setup
- Choosing a place for the printer
- Unpacking the printer
- Printer Components
- Installing the paper guide
- Opening the printer cover
- Removing the printer cover
- Connecting the Power Cord and turning the power ON and OFF
- Installing the ribbon cassette
- Removing the ribbon cassette
- Connecting to your computer using the parallel cable
- Ferrite Core Installation
- 2. Paper Handling
- Selecting paper types
- Cut-sheet paper
- Fanfold paper
- Loading cut-sheet paper
- Printing on cut-sheet paper
- Loading fanfold paper
- Printing on fanfold paper
- Parking fanfold paper
- Unparking fanfold paper
- 3. Control Panel Operations
- Switching between on-line and off-line
- Control panel functions in on-line mode
- Control panel functions in off-line mode
- 4. Using the EDS Mode
- About EDS Mode settings
- Entering the EDS Mode
- Selecting a EDS number
- Selecting a bank
- Selecting a switch
- Changing a switch setting
- Printing the current EDS settings
- Exiting the EDS Modes
- 5. Control Codes List
- < ESC/P-K mode>
- 6. Troubleshooting
- Short test
- Long test
- Hexadecimal dump
- Adjusting the dot alignment
- Troubleshooting guide
– 29 –
Pressing the LINE FEED button
The printer executes micro forward paper feed, and the auto loading
value is increased.
Pressing the SET/PARK/EJECT button
The printer executes micro reverse paper feed, and the auto loading
value is decreased.
The auto loading value must be greater than 0 inch. If the auto loading
value is less than 14/360 inch, the micro reverse paper feed is not
executed.
A micro paper feed moves the paper by 1/60 inch. When the printer exits
from the auto loading position change mode, a short buzzer sounds twice,
and all LEDs return to their previous conditions.
Set top of form (TOF)
While holding down the SET/PARK/EJECT button, press the LINE
FEED button. The vertical position is reset to the first line.
Buffer clear & All reset
While holding down the SET/PARK/EJECT button, press the ON LINE
button. Keep both buttons held down until the printer beeps once to clear
the data buffer. Continue to hold down both buttons until the printer
beeps again three times to reset all the settings.
After releasing the buttons, the printer is initialized in the same way as
a power-on reset.