Printer User Manual
Table Of Contents
- Contents
- 1. Printer Setup
- Choosing a place for the printer
- Unpacking the printer
- Printer Components
- Installing the paper guide
- Opening the printer cover
- Removing the printer cover
- Connecting the Power Cord and turning the power ON and OFF
- Installing the ribbon cassette
- Removing the ribbon cassette
- Connecting to your computer using the parallel cable
- Ferrite Core Installation
- 2. Paper Handling
- Selecting paper types
- Cut-sheet paper
- Fanfold paper
- Loading cut-sheet paper
- Printing on cut-sheet paper
- Loading fanfold paper
- Printing on fanfold paper
- Parking fanfold paper
- Unparking fanfold paper
- 3. Control Panel Operations
- Switching between on-line and off-line
- Control panel functions in on-line mode
- Control panel functions in off-line mode
- 4. Using the EDS Mode
- About EDS Mode settings
- Entering the EDS Mode
- Selecting a EDS number
- Selecting a bank
- Selecting a switch
- Changing a switch setting
- Printing the current EDS settings
- Exiting the EDS Modes
- 5. Control Codes List
- < ESC/P-K mode>
- 6. Troubleshooting
- Short test
- Long test
- Hexadecimal dump
- Adjusting the dot alignment
- Troubleshooting guide
– 24 –
ENGLISH
3. Control Panel Operations
The control panel gives you push-button control over the printer’s
operations. It also includes indicator lights, which tell you the current
status of the printer at a glance.
This chapter describes control panel functions that can be performed
while the printer is turned on and either on-line or off-line. The buttons
perform different functions in the EDS and Dot Adjustment Modes.
Functions of control panel buttons in these modes are described in the
relevant sections covering them.
POWER
ON LINE
SET/PARK
EJECT
LINE FEED
FORM FEED
MICRO FEED
MODE
TEAR OFF
P.E.
ON LINE button
SET/PARK/EJECT button
LINE FEED button
POWER indicator
PRINT MODE indicator
ON LINE indicator