Printer User Manual
Table Of Contents
- Contents
- 1. Printer Setup
- Choosing a place for the printer
- Unpacking the printer
- Printer Components
- Installing the paper guide
- Opening the printer cover
- Removing the printer cover
- Connecting the Power Cord and turning the power ON and OFF
- Installing the ribbon cassette
- Removing the ribbon cassette
- Connecting to your computer using the parallel cable
- Ferrite Core Installation
- 2. Paper Handling
- Selecting paper types
- Cut-sheet paper
- Fanfold paper
- Loading cut-sheet paper
- Printing on cut-sheet paper
- Loading fanfold paper
- Printing on fanfold paper
- Parking fanfold paper
- Unparking fanfold paper
- 3. Control Panel Operations
- Switching between on-line and off-line
- Control panel functions in on-line mode
- Control panel functions in off-line mode
- 4. Using the EDS Mode
- About EDS Mode settings
- Entering the EDS Mode
- Selecting a EDS number
- Selecting a bank
- Selecting a switch
- Changing a switch setting
- Printing the current EDS settings
- Exiting the EDS Modes
- 5. Control Codes List
- < ESC/P-K mode>
- 6. Troubleshooting
- Short test
- Long test
- Hexadecimal dump
- Adjusting the dot alignment
- Troubleshooting guide
– 21 –
9. Close the tractor covers. At this point you can make final adjustments
to the paper position by releasing the gray levers and moving the
tractors. The paper should lie flat with no buckling or bulging (tractors
too close) or no stretching or elongation of the holes (tractors too far
apart). After making these adjustments, be sure that you re-lock the
tractors by pushing the gray levers back into their original positions.
10.Turn the power on.
11.Press the control panel’s SET/PARK/EJECT button and the paper
will feed to the starting position.