Printer User Manual
Table Of Contents
- Contents
- 1. Printer Setup
- Choosing a place for the printer
- Unpacking the printer
- Printer Components
- Installing the paper guide
- Opening the printer cover
- Removing the printer cover
- Connecting the Power Cord and turning the power ON and OFF
- Installing the ribbon cassette
- Removing the ribbon cassette
- Connecting to your computer using the parallel cable
- Ferrite Core Installation
- 2. Paper Handling
- Selecting paper types
- Cut-sheet paper
- Fanfold paper
- Loading cut-sheet paper
- Printing on cut-sheet paper
- Loading fanfold paper
- Printing on fanfold paper
- Parking fanfold paper
- Unparking fanfold paper
- 3. Control Panel Operations
- Switching between on-line and off-line
- Control panel functions in on-line mode
- Control panel functions in off-line mode
- 4. Using the EDS Mode
- About EDS Mode settings
- Entering the EDS Mode
- Selecting a EDS number
- Selecting a bank
- Selecting a switch
- Changing a switch setting
- Printing the current EDS settings
- Exiting the EDS Modes
- 5. Control Codes List
- < ESC/P-K mode>
- 6. Troubleshooting
- Short test
- Long test
- Hexadecimal dump
- Adjusting the dot alignment
- Troubleshooting guide
– 19 –
4. Set the adjustment lever to the value that matches the thickness of the
paper you are using. The setting for normal paper is 1. Set the lever
to a larger value for thicker paper, or to a smaller value for thinner
paper. See the table on page 15 for details.
4
5
1
2
3
Adjustment lever
1
2
3
4
5
5. Unlock the tractor on the left (when viewing the printer from behind)
by pulling its gray lever up, and adjust the position of the left tractor.
Note that there is a guide inside the printer in front of the left tractor.
The ▲ mark of the guide indicates where the left margin of the
printing will be.
6. Once the left tractor is aligned the way you want it, push the gray lever
back down to lock it in place.