Printer User Manual
Table Of Contents
- Contents
- 1. Printer Setup
- Choosing a place for the printer
- Unpacking the printer
- Printer Components
- Installing the paper guide
- Opening the printer cover
- Removing the printer cover
- Connecting the Power Cord and turning the power ON and OFF
- Installing the ribbon cassette
- Removing the ribbon cassette
- Connecting to your computer using the parallel cable
- Ferrite Core Installation
- 2. Paper Handling
- Selecting paper types
- Cut-sheet paper
- Fanfold paper
- Loading cut-sheet paper
- Printing on cut-sheet paper
- Loading fanfold paper
- Printing on fanfold paper
- Parking fanfold paper
- Unparking fanfold paper
- 3. Control Panel Operations
- Switching between on-line and off-line
- Control panel functions in on-line mode
- Control panel functions in off-line mode
- 4. Using the EDS Mode
- About EDS Mode settings
- Entering the EDS Mode
- Selecting a EDS number
- Selecting a bank
- Selecting a switch
- Changing a switch setting
- Printing the current EDS settings
- Exiting the EDS Modes
- 5. Control Codes List
- < ESC/P-K mode>
- 6. Troubleshooting
- Short test
- Long test
- Hexadecimal dump
- Adjusting the dot alignment
- Troubleshooting guide
– 18 –
ENGLISH
Loading fanfold paper
This section describes the procedure for loading fanfold paper. You can
also use cut-sheet paper. For details on using cut-sheet paper, see
“Loading cut-sheet paper” on page 14.
1. Position the stack of paper behind the printer. The following figure
shows the correct path for fanfold paper.
Important!
To protect against paper jams, make sure that the fanfold paper is
stacked in a position that is lower than the printer.
To decrease paper jams, be sure that the perforations do not get
caught in anything in the paper path.
2. Make sure that the printer is turned off.
3. Set the release lever to the fanfold position.