Printer User Manual
Table Of Contents
- Contents
- 1. Printer Setup
- Choosing a place for the printer
- Unpacking the printer
- Printer Components
- Installing the paper guide
- Opening the printer cover
- Removing the printer cover
- Connecting the Power Cord and turning the power ON and OFF
- Installing the ribbon cassette
- Removing the ribbon cassette
- Connecting to your computer using the parallel cable
- Ferrite Core Installation
- 2. Paper Handling
- Selecting paper types
- Cut-sheet paper
- Fanfold paper
- Loading cut-sheet paper
- Printing on cut-sheet paper
- Loading fanfold paper
- Printing on fanfold paper
- Parking fanfold paper
- Unparking fanfold paper
- 3. Control Panel Operations
- Switching between on-line and off-line
- Control panel functions in on-line mode
- Control panel functions in off-line mode
- 4. Using the EDS Mode
- About EDS Mode settings
- Entering the EDS Mode
- Selecting a EDS number
- Selecting a bank
- Selecting a switch
- Changing a switch setting
- Printing the current EDS settings
- Exiting the EDS Modes
- 5. Control Codes List
- < ESC/P-K mode>
- 6. Troubleshooting
- Short test
- Long test
- Hexadecimal dump
- Adjusting the dot alignment
- Troubleshooting guide
– 14 –
ENGLISH
Loading cut-sheet paper
This section describes the procedure for loading cut-sheet paper. You can
also use fanfold paper. For details on using fanfold paper, see “Loading
fanfold paper” on page 18. If the fanfold paper is currently loaded, first
park the fanfold paper using the procedures described in “Parking
fanfold paper” on page 23.
1. Set the release lever to the cut-sheet position.
2. Set the adjustment lever to the value that matches the thickness of the
paper you are using. The setting for normal paper is 1. Set the lever to a
larger value for thicker paper, or to a smaller value for thinner paper.
4
5
1
2
3
Adjustment lever
1
2
3
4
5