Printer User Manual
Table Of Contents
- Contents
- 1. Printer Setup
- Choosing a place for the printer
- Unpacking the printer
- Printer Components
- Installing the paper guide
- Opening the printer cover
- Removing the printer cover
- Connecting the Power Cord and turning the power ON and OFF
- Installing the ribbon cassette
- Removing the ribbon cassette
- Connecting to your computer using the parallel cable
- Ferrite Core Installation
- 2. Paper Handling
- Selecting paper types
- Cut-sheet paper
- Fanfold paper
- Loading cut-sheet paper
- Printing on cut-sheet paper
- Loading fanfold paper
- Printing on fanfold paper
- Parking fanfold paper
- Unparking fanfold paper
- 3. Control Panel Operations
- Switching between on-line and off-line
- Control panel functions in on-line mode
- Control panel functions in off-line mode
- 4. Using the EDS Mode
- About EDS Mode settings
- Entering the EDS Mode
- Selecting a EDS number
- Selecting a bank
- Selecting a switch
- Changing a switch setting
- Printing the current EDS settings
- Exiting the EDS Modes
- 5. Control Codes List
- < ESC/P-K mode>
- 6. Troubleshooting
- Short test
- Long test
- Hexadecimal dump
- Adjusting the dot alignment
- Troubleshooting guide
– 12 –
ENGLISH
Important!
Make sure that the printer is unplugged from the AC outlet and that
the computer is turned off before connecting the parallel cable.
1. Connect one end of the parallel cable to the parallel port of your
computer. The parallel port is usually labeled “Printer,” “Parallel,”
“PRN,” “LPT1,” or something similar.
2. Connect the other end of the parallel cable into the socket on the back
of the printer and secure it in place with the clips.
Note:
If your computer is located to the right of the printer, run the cable
under the computer through the groove at the bottom of the printer.
This will prevent the cable from interfering with the fanfold paper.
You can also run the power cord under the printer.