User Guide

- 26 -
5. General Specications
Item Specications
Printing method Direct line thermal printing
Characters per line Maximum 64 cpl
Character size
Alphanumeric characters: 9 X 24 dots, 12 X 24 dots, and 9 X 17 dots
Japanese characters: 24 X 24 dots
Character types
Alphanumeric characters, expanded graphic characters, JIS Level-1 Kanji Set,
JIS Level-2 Kanji Set, and special characters
Dot density 203 dpi (8 dots/mm)
Printing width 72mm, 576 dots
Print speed 75 mm/s (max)
Bluetooth Spec. Bluetooth V2.1+EDR / Class 2 (10 m)
Frequency Range 2.4 GHz ISM BAND
Data Transmission Rate 57600 bps Fixed
Interface Bluetooth Data bit 8 Data bit Fixed
Parity bit No Parity Fixed.
Stop bit 1 Stop bit Fixed.
SSP Incompatible
RS-232C & Bluetooth Ver 2.1+EDR
Emulation ESC/POS, FIrmware version 3.0 or older : Star Line / 3.1 or later : StarPRNT
Roll paper Thermal roll paper (80 mm wide with a diameter of Ф50 mm)
Barcode
1D: JAN, EAN, UPC, ITF, Code39, Code93, Code128, CODABAR(NW-7),
GS1 Barcode(StarPRNT only)
2D: PDF417, QR Code, DATA Matrix(ESC/POS only), GS1 2Dcode(StarPRNT only),
GS1 Conposite(StarPRNT only)
Receive buer size 1M bytes *1)
MSR
SM-T300i : Not Supported MSR
SM-T301i : ISO 7810 / 7811 / 7812 1st and 2nd Track Reading
LCD 128×32 Dots FSTN (Blue LED Backlight)
Battery pack Rechargeable 7.4V DC 1800mAh
Battery operating time
Approximately 11 hour printing (12 receipts per hour)
Approximately 13 hour prnting
(12 receipts per hour / auto power down mode)
Battery charger
Input: 100 to 250 V AC, 50 to 60 Hz
Output:8.4 VDC/0.8 A, Time required for full charge: 4 h
Environmental Requirements
Temperature *2 )
-10
o
C to 50
o
C (for operation)
-20
o
C to 60
o
C (for storage)
Humidity
30% to 80% (for operation)
10% to 90% (for storage)
Print head life Approximately 50 km
Drop resistance
1.5 m / 1.2 m (Model with Card Reader)
*Our test procedure, Not guarantee.
Dust protected, Splash proof IP54 Certied
*1)
If the quantity of data which is printed at once is more than 1M byte on Bluetooth communication, it would cause the
buer to overow and the data to get damaged.
*2) Under 0°C, please change Density mode and Quality mode of the memory switch settings to both “High”.
If you want to print a delicate pattern like Barcode printing, please use the printer over 0°C.