User Guide

- 17 -
* Example:
When you want to change the settings of the printer mode as shown below,
<Before> Bluetooth-Auto / 9600 BPS / 8 DATA BIT / NO PARITY / 1 STOP BIT / DENSITY LOW /
LOW QUALITY / MARK NO USE / SENSOR LOW / PWDN1min Sleep
<After> Bluetooth-Mac / 9600 BPS / 7 DDATA BIT / EVEN PARITY / 1 STOP BIT / DENSITY LOW /
HIGH QUALITY / MARK NO USE / SENSOR HIGH / PWDN1min Sleep
1
Press and hold the POWER & FEED buttons for 3 seconds. After the ERROR LED ashes ve
times, you can congure the settings.
Press the POWER button twice and the connection mode will be changed to “Bluetooth-Mac”.
Display: Bluetooth-Auto
g
UART Mode
g
Bluetooth-Mac
2
Press the FEED button once and then you can change the baud rate setting.
3
When the baud rate does not need to be changed, press the FEED button once again and you
can change the data bit setting. Press the POWER button once and the data bit will change to “7
bit”.
Display: 8 DATA BIT
g
7 DATA BIT
4
Press the FEED button once and then you can change the baud rate setting
.
Press the POWER button twice and the parity bit will be changed to “EVEN PARITY”.
Display: NO PARITY
g
ODD PARITY
g
EVEN PARITY
5
P
ress the FEED button once and then you can change the stop bit setting
.
When the stop bit does not need to be changed, press the FEED button once again and you
can change the print density setting.
6
When the print density does not need to be changed, press the FEED button once again and
you can change the print quality setting.
Display: LOW QUALITY g HIGH QUALITY
5. After you have congured all of the settings, press and release FEED and MODE at the same time.
The new settings will be printed.
If the settings were not congured correctly, follow the above procedure to congure the settings
again.
3. To swith the printer mode , press FEED button.
4. If the current printer mode does not need to be changed, press FEED button again and swith the
printer mode. To change the setting, press POWER button.