SMART LIGHT 2000™ INSTALLATION AND OPERATIONS INSTRUCTIONS ‐1‐
THANK YOU FOR CHOOSING THE SMART LIGHT 2000™! We are very pleased that you have chosen our product to enhance your camping experience! At Starlights, Inc., we are passionate about improving your safety, security, and convenience.
IMPORTANT NOTES Using or attaching other accessories or devices can cause a hazard, may damage the unit, and WILL VOID the WARRANTY. INSTALLING THE Smart Light 2000™ IMPORTANT-DISCONNECT THE BATTERY STEP 1: Remove the old lighting fixture from the RV and clean area of all old sealer, dirt, etc. NOTE: If you are using the optional Fuse Box to activate your Scare Light now is the time to add that accessory using the installation instruction included with the Fuse Box.
Potentiometer, remove the clear plug cover by gently placing finger nail in the grove at the bottom of the plastic frame surrounding the clear plug. Then, lift outward and remove the clear plug. Take great care when adjusting not to touch the circuit board, which WILL VOID the WARRANTY. PIR (PASSIVE INFRARED SENSOR) NOTE: A note about this state of the art technology: This PIR sensor detects thermal mass.
minute. If the fixture again detects motion before the (1) minute is up, then the timer will reset, and the count-down will recommence. If no other motion is detected, then the light will deactivate, and the area around your coach will continue to be monitored. Finally, don’t be alarmed if the Smart Light 2000™ does not detect your motion at the exact same point each time. A variety of factors dictate when and at which point the motion detection unit will activate the light bulb.
Smart Light 2000™ Trouble Shooting Guide SYMPTOM Light won't come on. While in Porch Light Mode the LED flashes "RED" but the Light Bulb does Work. CAUSE • • • • • POSSIBLE SOLUTION Power not on. Grounded incorrectly. Light bulb blown. Low Battery Condition (Line Voltage to fixture dropped to 11.5 Volts or below for a period of 45 seconds). Too much load on wire supplying power to the fixture. • • • • • Turn on indoor switch or check fuse. Check ground wire. Check bulb and replace if necessary.
Smart Light 2000™ Trouble Shooting Guide --continued-SYMPTOM While in "Auto Mode" the LED flashes "RED" but the Light Bulb does "NOT" Work. CAUSE • • Low Battery Condition (Line Voltage to fixture dropped to 11.5 Volts or below for a period of 45 seconds). Too much load on wire supplying power to the fixture. POSSIBLE SOLUTION • • Charge or replace the Coach the Battery. Check breaker on Coach charging system and reset if necessary. • Up-size wire gauge from distribution panel to Fixture.
