Manual

DO NOT oil the powder slide or allow oil to run into it from the machine; keep hopper clean
and dry.
DO NOT FINGER the safety cam after the first finished shell operates it as there is danger
of double charging if you do.
DO NOT FORGET your powder hopper and let it run empty.
DO NOT use gasoline or solvent on your shells. It makes them so dry that they may stick to
the die and cause scratches. After your shells are clean and free of grit just before starting to
reload, dip the tips of your fingers in hydrous lanolin and stir the shells. A very little lubrication
will keep them from sticking.
IMPORTANT NOTICE
NEVER USE FORCE WHEN HANDLING PRIMERS
Should a defective primer become lodged in the tube, a few taps on the side of the tube will
usually dislodge it. Operators have been injured by trying to drive the primers through the tubes
with a piece of metal.
After all a primer that would not explode by hammering will not do so in the gun.
C
ARE OF STAR PROGRESSIVE LOADER
Keep all parts subject to wear, including cam that operates angle lever, slightly lubricated
(except the powder carrier). Lubricate primer slide with small amount of dry graphite only.
(Keep tubes clean and dry.)
Keep this instruction sheet and refer to it occasionally.
- 4 -