Manual

Remove pin (20) from the trigger (19) and both pieces will come out without difficutly,
together with the sear bar (23) and interrupter (25), when pulling it downwards.
To remove the sear bar (23) from the trigger (19), push the sear bar pin out, thus
freeing it as well as the trigger plunger (22) and its spring (21).
Remove sear pin (15) and this will free the sear spring (16).
Using a copper or brass punch, drive out the hammer pin (11) from right to left from
the hammer (06). This releases both the spring (09) and plunger (10).
Withdraw the thumb safety (36), grasping the thumb piece and turning to the right,
lift it up. Care should be taken to let the plunger (38) and its spring (39) jump away when
released.
The slide stop (41) has a pin which when removed frees the retaining plunger and its
spring.
The extractor (66) may now be removed, pushing the pin (67) from below upwards.
This frees the spring (69).
Remove the rear sight (74) from right to left, drifting slightly with a copper punch.
Push the retaining pin (71) of the firing pin (70) upwards from the slide and tilting the
slide release this piece and its spring (72).
TO REASSEMBLE THE PISTOL
Reverse the beforementioned procedure.