User's Manual

station antenna, the lower the power output. Before a phone

model is available for sale to the public, it must be tested and

certified to the FCC that it does not exceed the limit established

by the government adopted requirement for safe exposure. The

tests are performed in positions and locations (e.g., at the ear

and worn on the body) as required by the FCC for each model.

The highest SAR value for this model phone when tested for

use at the ear is

0.655W/Kg and when worn on the body, as

described in this user guide, is

0.423W/Kg(Body-worn

measurements differ among phone models, depending upon

available accessories and FCC requirements). While there may

be differences between the SAR levels of various phones and

at various positions, they all meet the government requirement

for safe exposure. The FCC has granted an Equipment

Authorization for this model phone with all reported SAR levels

evaluated as in compliance with the FCC RFexposure

guidelines. SAR information on this model phone is on file with

the FCC and can be found under the Display Grant section of

http://www.fcc.gov/ oet/fccid after searching on

FCC ID: PRMA18 Additional information on Specific

Absorption Rates (SAR) can be found on the Cellular

Telecommunications Industry Asso-ciation (CTIA) web-site at

http://www.wow-com.com. * In the United States and Canada,

the SAR limit for mobile phones used by the public is 1.6

watts/kg (W/kg) averaged over one gram of tissue. The

standard incorporates a sub-stantial margin of safety to give

additional protection for the public and to account for any

variations in measurements.

Body-worn Operation

This device was tested for typical body-worn operations. To

comply with RF exposure requirements, a minimum separation

distance of 15mm must be maintained between the user’s body

and the handset, including the antenna. Third-party belt-clips,

holsters, and similar accessories used by this device should not

contain any metallic components. Body-worn accessories that

do not meet these requirements may not comply with RF

exposure requirements and should be avoided. Use only the

supplied or an approved antenna.