IMPORTANT SAFETY INSTRUCTIONS 1. Read Instructions – All the safety and operating instructions should be read before this product is operated. 2. Retain Instructions － The safety and operating instructions should be retained for future reference. 3. Heed Warnings － All warnings on the appliance and in the operating instructions should be adhered to. 4. Follow Instructions － All operating and use instructions should be followed. 5.
FEATURES • • • • • • • Compact design User replaceable crossfader 2 phono, 2 line, 1 microphone input Gain, Treble, and Bass Controls on Channels Powerful stereo headphone output Cue Pan Selector (Ch.1-Ch.
MIXER FEATURES 1. Input fader - Controls individual source levels (channels) in the mix. 2. Input toggle switch - Selects which source will be active based on what you have connected to the rear panel input section (phono/line). 3. Treble and Bass EQ - Adjusts the high and low frequency levels of the input channels for good sound. 4. Channel Gain - Adjusts the pre-fader volume for cleaner sound. 5. Replaceable Crossfader - Achieves clean fades between the two input channels. "Hard left" selects Channel 1.
QUICK SETUP DIAGRAM Study this setup diagram. Make sure all faders are at "zero" and all devices are off. First, connect all input sources and processors. Next, connect your microphone and monitor headphones. Finally, connect the stereo outputs to the power amplifier(s) and/or audio receivers such as tape decks. Plug your mixer into AC power. Now you are ready to switch everything on.
SPECIFICATIONS SENSITIVITY OF INPUT (LEVEL/IMPEDANCE): LINE -14dB/47K OHM ±3dB PHONO -50dB /47K OHM ±3dB MIC -54dB /6K OHM ±3dB OUTPUT (LEVEL/IMPEDANCE): MASTER (RCA) 0dB/47K OHM ±3dB PHONES (LOAD=32 OHM) -3dB/33 OHM ±3dB MAX. OUTPUT (LOAD=47K, THD=5%) MASTER (RCA) MORE THAN 18dB (8V) PHONES (LOAD=32 OHM) MORE THAN 5dB (1.
Stanton Magnetics, Inc. – Warranty Provision – Returns for Repairs or Replacement WARRANTY Through Stanton’s authorized dealers around the World, Stanton, or one of Stanton’s authorized distributors outside the U.S., will, without charge, repair or replace, at the sole discretion of the entity responsible for making the repair or providing the replacement, any Stanton merchandise proved defective in material or workmanship for a period of one (1) year following the date of original purchase.
cut along dotted line State Where did you buy this product? Date of Purchase Serial Number Model Number PRODUCT INFO Telephone Country City Address Name PERSONAL INFO Zip If you have internet access, please register your product at www.stantondj.com. Otherwise, return this card completely filled out in order to validate your warranty.
PLACE STAMP HERE Stanton Magnetics, Inc. 3000 SW 42nd Street Hollywood, FL 33312 U.S.A.
