User Manual

Setup
There are a number of default MIDI settings you can adjust directly from your hardware. You can set SHIFT button behavior, PUSH-
TO-KILL encoder behavior, and your MIDI channel. Your DJC.4 sends MIDI data over 4 channels at once, allowing a unique channel
message per deck.
CHANNEL
You can change channel by hold the LEFT DECK “DECK SWITCH” button for 3 seconds and press the Left Deck Hot Cue button 1 to 4.
Default channel is Channel 1~4
Hot Cue 1 for Channel 1~4
Hot Cue 2 for Channel 5~8
Hot Cue 3 for Channel 9~12
Hot Cue 4 for Channel 13~16
SETTING
You can, at any time, adjust the following settings. Make sure that you wish to change these settings though, as the default software
mappings that come with your DJC.4 are set from the factory.
•SHIFT button
You can change the SHIFT mode type from HOLD to TOGGLE by hold the left deck “DECK SWITCH” button for 3 seconds and press
the “Channel 1 Monitor Cue” button to switch the mode. Default setting is “HOLD” mode (SHIFT is only engaged when you press
and hold the button)
.
•Sampler
You can set your SAMPLER BUTTON(S) default from DECK to GLOBAL. The default (used by most DJ software) is DECK (sample
button note values are sent on a per-deck basis). You can change the Sampler setting by hold the left deck “DECK SWITCH”
button for 3 seconds and press the “Channel 2 monitor Cue” button to switch the mode.
•EQ KILL button
You can switch On/Off the EQ PUSH-TO-KILL function by holding the left deck “DECK SWITCH” button for 3 seconds, followed by
pressing the “Load B/D” button to switch the mode. The default setting enables EQ PUSH-TO-KILL.