Datasheet

Product code
:
8491
EN (English) Revision date: 11/14/2017 3/7
Methods for cleaning up
Stop the flow of materi
al, if this is without
risk. Large Spills: Dike the spilled
material, where this is possible. Cover with plastic sheet to prevent spreading.
Following product recovery, flush area with water. Small spills: Absorb in
vermiculite, dry sand or earth and place into containers. Clean surface
thoroughly to remove residual contamination.
Other information
Dispose of materials or solid residues at an authorized site
. Never return spills in
original containers for re-use.
6.4. Reference to other sections
For further information refer to section 13.
7. SECTION 7: Handling and storage
7.1. Precautions for safe handling
Precautions for safe handling
Ensure good ventilation of the work station. Wear
personal protective equipment.
Hygiene measures
Do not eat, drink or
smoke when
using this product. Always wash hands after
handling the product.
7.2. Conditions for safe storage, including any incompatibilities
Storage conditions
Store in original tightly closed container. Store away
from other materials.
7.3. Specific end use(s)
Soft soldering.
8. SECTION 8: Exposure controls/personal protection
8.1. Control parameters
Contains no substances with occupational exposure limits.
DNEL: Derived no
effect level
No data available
Components
Type
Route
Value
Form
Rosin, reac
tion products
with formaldehyde (91081-
53-7)
Worker
Dermal
25 mg/kg bodyweight/day
Long
-
term
-
systemic effects
Inhalation:
176.32 mg/m³
Long
-
term
-
systemic effects
Consumer
Oral
15 mg/kg bodyweight/day
Long
-
term
-
systemic effects
Inhalation:
52.174 mg/m³
Long
-
term
-
systemic effects
Dermal
15 mg/kg bodyweight/day
Long
-
term
-
systemic effects
PNEC: Predicted no
effect concentration
No data available
Components
Type
Route
Value
Form
Rosin, reaction products
with formaldehyde (91081-
53-7)
Not applicabl
e
Freshwater
0.1 mg/l
Seawater
0.01 mg/l
sediment
116.86 mg/kg dwt
Freshwater
sediment
11.686 mg/kg dwt
Seawater
Soil
23.2 mg/kg dwt
STP
1000 mg/l
8.2. Exposure controls
Appropriate engineering controls
Explosion
-
proof general and local exhaust ventilation,Good general ventilation
(typically 10 air changes per hour) should be used. Ventilation rates should be
matched to conditions. If applicable, use process enclosures, local exhaust
ventilation, or other engineering controls to maintain airborne levels below
recommended exposure limits. If exposure limits have not been established,
maintain airborne levels to an acceptable level,Eye wash fountain is
recommended