Datasheet

The above values are typical and represent no form of specification. The Data Sheet serves for information purposes. Any verbal or written advise is not binding for
the company, whether such information originates from the company offices or from a sales representative. This is also in respect of any protection rights of third
parties, and does not release the customer from the responsibility of verifying the products of the company for suitability of use for the intended process or purpose.
Should any liability on the part of the company arise, the company will only indemnify for loss or damage to the same extent as for defects in quality.
TI_FG_ FluxGele_EN.doc Page 5 of 6 Issue: 28.04.06
STANNOL GmbH
Oskarstraße 3-7
•
42283 Wuppertal
•
Tel. [phone]
•
Telefax [phone]
•
E-Mail [e-mail]
•
Web www.stannol.de
Wenn’s ums Löten geht
When it’s about soldering
Quand il s’agit du soudage
Area of spread/mm
2
, 200mg solder pellets, Solder bath 300°C
Flux-Gel
Cu-test
coupon
SnAg
Cu-test
coupon
SnPb
Brass test
coupon
SnAg
Brass test
coupon
SnPb
Multifix 450-01 33,2 38,5 38,5 52,8
Kolopaste No. 8 39,6 58,8 33,2 64,3
Smart-Gel No. 8D 38,5 59,4 35,3 63,6
Flux-Gel RMA04 54,1 83,3 34,2 49,0
Flux-Gel 135 44,2 91,6 34,2 52,8
Flux-Gel HX21 43,0 78,5 32,2 45,4
Dispensing properties:
All of the flux-gels are suitable for dispensing, but there are some points to regard:
When using an air pressure system, it is important to make the right choice for the needle
and pressure. In the table below there are recommendations for needle sizes. The inside
diameter should not be smaller than indicated in the table, larger needle diameters are
possible, if accordingly the pressure impulse (pressure/time) is adapted. Another
alternative, which is suitable straight for proportioning by hand, are conical TT needles
made of plastic. They are suitable particularly for very viscous media, which have poor
flow characteristics.
Product Recommended Conditions
Multifix 450-01 3 bar pink needle Inner diameter 0,58 mm
Kolopaste No.8 2 bar pink needle
Inner diameter 0,58 mm or conical
TT–Needle for better flow properties
Smart-Gel No. 8D 2 bar pink needle Inner diameter 0,25 mm
RMA04, 3 bar pink needle Inner diameter 0,58 mm
Flux-Gel 135 3 bar pink needle Inner diameter 0,58 mm
Flux-Gel HX21 1,5 bar green needle
Inner diameter 0,84 mm or conical
TT–Needle for better flow properties
Dosing needles need care, in particular with longer operating interrupts. The gels tend to
dry and the needles start blocking. This can be avoided, if the needle is removed and
rinsed with a cleaning gel, by simply putting the needles onto the STANNOL
®
Clean Gel
cartridge.
Clean-Gel is a coloured gel for rinsing the dosing needle, which keeps these open during
a very long period. Before a new use the needle must be filled with the appropriate flux