Petrol grass trimmer GB Original instructions STR-750 Petrol grass trimmer
GB 2 Manufactured under license by: MATRIX GmbH • Postauer Straße 26 • D-84109 Wörth/Isar • www.matrix-direct.net Stanley is a registered trademark of The Stanley Works or its affiliates and is used under license.
5 8 6 1 16 3 4 2 6 16 13 5 9 7 4 19 10 15 17 14 18 11 A1 12 3
Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9 Fig.10 Fig.11 Fig.
G B Table of Contents 1. Symbols 1. Symbols ........................................................................5 2. Intended use.................................................................6 3. Safety instructions....................................................... 6 4. Parts List.......................................................................8 5. Assembly.......................................................................9 6. FueL.....................................................
G B 2. Intended use The intended purpose of the device is the trimming of lawns or grass for private use. If the device is not used for its intended purpose, or in case of any modification to the device, the manufacturer does not accept any liability. Please also observe the safety notes, the assembly and operating instructions, as well as the general applicable accident prevention regulations. 3. Safety instructions Warnings! Read this instruction carefully before operating this machine.
G B Keep hands and feet away from the cutting means at all times, especially when he motor are switched on) 7. Never allow children or people unfamiliar with the instructions to use the machine. 8. Stop using the machine while people, especially children, or pets are nearby. 9. Only use the machine in daylight or good artificial light. 10.
G B Never fill the tank in enclosed spaces, such as basements or sheds. There is a risk of poisoning and explosion! 9. Avoid skin contact with petrol. 10. Do not eat or drink, while you are refuelling the machine. If you have swallowed petrol or oil, or if petrol or oil has got into your eyes, then seek the advice of a doctor immediately. 11. Close the tank lid immediately after filling the tank. Make sure that it is properly closed. 12. Never use the machine without an air filter.
G B 5. Assembly WARNING! The machine must be fully assembled before operation! Do not use a machine that is only partly assembled or assembled with damaged parts. Always use gloves during assembly. Disconnect the spark plug connector from the spark plug. INTENDED USE 1. This machine is designated with a maximum power output of max. 0.75 kW. 2. With attached trimming guard and fitted trimmer head, the grass trimmer is intended to be used to cut small weeds, grass or similar soft vegetation. 3.
G B use the bigger trimming guard for cutting. Ask your local authorities. INSTALL CUTTING ATTACHMENT Install spool assembly 1. Make sure that the guard has been attached properly. 2. Attach the trimmer head onto the spindle. 3. Secure the trimmer head with bumper clockwise. 6.
G B 4. Press throttle interlock and throttle trigger. 1 2 ADJUST CUTTING ANGLE 1. The angle of gear head can be adjusted in 3 positions according to the performed work. 5. Pull the recoil starter to start engine and the move choke lever to “WARM START” position. Now, your machine is under idle speed condition. 6. Let the machine run in idle speed for 10-15s to warm up. 7. Depress throttle trigger to get full engine speed for operation. Start warm engine 1. Set ignition switch to “I” position. 2.
G B 5. Move the machine with slow and regular horizontal movements from the right to the left and then lead it back to starting point before trimming the next row. 1 2. Pay special attention when performing the work close to trees and bushes. The cutting means can damage sensitive bark, and damage fence posts. 3. Regularly remove clippings and dirt around the trimmer head with a switched off product. 4. After use, switch the machine off, unplug the spark plug connector and let it cool down. 8.
G B AIR FILTER 1. Inspect the air filter regularly. Clean it at least every 25 hours or replace with a new one if necessary. 2. Press the air filter seat,open the air filter case. Tap the filter on a stable surface to remove dust. Use high pressure air (max. 3 bar) to remove stubborn dust. A 3. Apply a small amount of air filter oil on the filter to increase the filter performance. Wring out surplus oil and put the filter into the case. 4. Close the air filter case. FUEL 1.
G B 5. To replace the line take out the spool and remove the remaining cutting line. 6. Cut a new 6m long cutting line with a diameter of 2mm. Form a loop at the middle of the line and insert this loop into the hook on the spool. 7. Wind the two parts of the cutting line in clockwise direction firmly around the spool each part in the guide on the spool. 8. Insert each end of the threads in the respective holes. The threads should stick out 150 mm on each side. 9.
G B 10.
Original Konformitätserklärung GB hereby declares the following conformity under the EU Directive and standards for the following article Petrol grass trimmer / STR-750 2006/42/EC 2006/95/EC 2002/95/EC_2005/618/EC 2014/30/EU R&TTED 1999/5/EC 2000/14/EC_2005/88/EC 95/54/EC 97/68/EC_2012/46/EC EN ISO 11806-1; EN ISO 14982 Geräuschemission 2000/14/EC, Anhang III & 2005/88/EC, Garantierter Schallleistungspegel: LwA= 114 dB(A), Benannte Stelle , Name und Anschrift der beteiligten Stelle: TÜV SÜD certificati
GARANTIE GB Guarantee This appliance is a quality product. It was designed in compliance with current technical standards and made carefully using normal, good quality materials. The warranty period is 24 months and commences on the date of purchase, which can be verified by the receipt, invoice or delivery note.
Petrol grass trimmer / STR-750 GB WARRANTY Purchased at: in (city, street): Name of customer: Street address: Postal code, city: Telephone: Date, signature: Fault description: 18
