Instructions / Assembly
WARNING!
While engine is running temperature may exceed 150°F (65°C). Severe burns may occur.
Exhaust heat/gasses can ignite combustibles, structures or damage fuel tank causing a fire.
• Do NOT touch hot surfaces and do avoid exhaust gasses.
• Allow water pump to cool before touching.
• Keep at least 6 ft. (183cm) clearance on all sides of water pump including overhead clear.
• Reflective exhaust heat may damage fuel tank causing fire.
• Code of Federal Regulation(CFR) Title 36 Parks, Forests, and Public Property require equipment powered by
an internal combustion engine to have a spark arrester, maintained in working order, complying to USDA Forest
servicestandard5100-‐1corlaterrevision.InthestateofCaliforniaasparkarresterisrequiredundersection4442
of the California Public resources code.
WARNING!
Unintentional sparking can result in fire or electrical shock.
WHEN TESTING FOR ENGINE SPARK
• Do NOT check for spark with the spark plug removed.
• Use approved spark plug tester.
WHEN REPAIRING OR ADJUSTING WATER PUMP
• Disconnect the spark plug wire from the spark plug and place the wire where it cannot contact spark plug.
NOTICE!
Improper use and care of this water pump will cause damage and shorten its lifespan. Failure to follow these
instructions will void all warranties.
• Do NOT operate your power equipment in inclement weather such as rain, snow and/or sleet.
• Never allow children or animals to be near this equipment during operation. Only qualified persons should
operate this equipment. Please follow all guidelines contained in this owner’s manual for the safe operation of this
equipment.
NOTE: Pumping of inflammable or corrosive liquids such as gasoline, seawater, chemical
solutions, alkaline liquids or acids is forbidden with any unit EXCEPT ST2CCWPLT-CA, Chemical
Corrosive Liquids Pump designed for this purpose!
Safety Instructions (continued)
8