User Manual

6
ENGLISH (Original Instructions)
Cable length (m)
7.5 15 25 30 45 60
Voltage Amperes Cable rated current (Ampere)
110-127 0 - 2.0 6 6 6 6 6 10
2.1 - 3.4 6 6 6 6 15 15
3.5 - 5.0 6 6 10 15 20 20
5.1 - 7.0 10 10 15 20 20 25
7.1 - 12.0 15 15 20 25 25 -
12.1 - 20.0 20 20 25 - - -
220-240 0 - 2.0 6 6 6 6 6 6
2.1 - 3.4 6 6 6 6 6 6
3.5 - 5.0 6 6 6 6 10 15
5.1 - 7.0 10 10 10 10 15 15
7.1 - 12.0 15 15 15 15 20 20
12.1 - 20.0 20 20 20 20 25 -
LABELS ON TOOL
The label on your tool may include the following symbols:
must read the instruction manual before use.
WARNING! To reduce the risk of injury, the
user
Wear safety glasses or goggles.
Wear ear protection.
Wear a dust mask.
V Volts Direct Current
A Amperes n
0
No-Load Speed
Hz Hertz Class II
Construction
W Watts Earthing
Terminal
min minutes Safety Alert
Symbol
Alternating
Current
/min. Revolutions or
Reciprocation
per minute
Position of date code
The Date Code, which also includes the year of manufacture,
is printed into the housing.
Example:
2017 XX JN
Year of manufacturing
PACKAGE CONTAINS
1 Random orbital sander
1 Sanding paper
1 Dust bag
1 Instruction manual
1 Warranty card
1 Service center list
Check for damage to the tool, parts or accessories which
may have occurred during transport.
Take the time to thoroughly read and understand this
manual prior to operation.
FEATURES (Fig A)
WARNING: Never modify the power tool or any
part of it. Damage or personal injury could result.
1. On/off switch
2. Electronic speed control dial
3. Dust bag
4. Dust bag collar
5. Dust extraction outlet
6. Sanding pad
7. Sanding paper
ASSEMBLY AND ADJUSTMENT
WARNING: To reduce the risk of serious personal
injury, turn tool off and disconnect tool from
power source before making any adjustments or
removing/installing attachments or accessories.
Before reconnecting the tool, depress and
release the trigger switch to ensure that the tool
is off. An accidental start-up can cause injury.
Fitting sanding paper (Figure. A,B)
WARNING! Never use the tool without a sanding
paper or accessory in place.
The tool uses 125 mm (5”) hook and loop sanding paper
with an 8 hole dust extraction pattern.
1. Place the tool on a table, sanding pad (6) up.
2. Place the sanding paper (7) directly on top of the
sanding pad.
3. Hold the sanding pad with one hand and align the dust
extraction holes.
4. Press the sanding paper firmly onto the sanding pad.
Setting the electronic speed control dial (Fig A)
The speed is infinitely variable from 0–13,000 min
-1
using
the electronic speed control dial (2).
Turn the electronic speed control dial to the required level.