Owner's Manual

TRANSPORT HANDLE ASSEMBLY
Insert transport handle into Transport handlebracket.
OPERATING INSTRUCTIONS
7
DRY PICK-UPDRY PICK-UP
NOTE:
1. With the power head in an upside down postition, slide the cartridge filter down over the filter cage,
push the filter seals against the power head.
2. Place filter cap into the top of the cartridge filter, hold the power head with one hand, turn the
handle on the filter cap clockwise to tighten, locking the filter into place.
3. To remove the cartridge filter for cleaning, again hold the power head and turn the filter cap
counter-clockwise to loosen and remove, slide the cartridge filter off the fi
lter cage.
4. To clean the cartridge filter shake or brush off excess dirt or rinse(from the inside of the filter) with
water, dry completely (approximately 24 hours) and re-install.
5. Slide collar of filter bag into cap guides.
6. When secured in place, expand bag and position around the inside of the tank.
NOTE: If the filter has been used for wet pick up, it must be cleaned and dried before using for
dry pick up.
UnlockLock
The cartridge filter can be used for wet or dry pick up; installation is the same for both. When
picking up large quantities of liquid, please refer to the “Wet Pick Up Operation” section in this manual.
Use the cartridge filter in position over the filter cage for most general dry material pick.