Use and Care Manual

UNPACKING & SET-UP SUMMARY
CASTER / ASSEMBLY
1.Pull lid latches in an outward motion, remove power head and some accessories that may
have been shipped in the tank.
2.Attach the casters according to the instruction in this manual.
1. Remove reusable filter and replace it with foam filter when you do wet pickups.
2. This wet/dry vac is equipped with a float mechanism which will rise automatically to cut off
the airflow when the liquid in the tank reaches a predetermined level. When this happens,
turn off vac, unplug the power cord, and empty the dust tank. You will know that the float
has shut the airflow off because the suction ceases and the motor noise becomes higher
in pitch due to increased motor speed. The liquid capacity may vary with the rate of pickup.
3.Before replacing power head, refer to this manual to ensure you have the proper filters installed
for your cleaning operation.
4.Replace power head, and apply pressure with thumb to each latch until it snaps tightly in place.
Make sure all lid latches are clamped securely.
5.Insert the flexible hose end into inlet of tank.
6.Attach
the extension wands to the accessor end of the hose. Apply slight pressure until fitting
is tight.
7.Attach one of the cleaning accessories (depending on your cleaning requirements) on the
extension wands. Twist slightly to tighten the connection.
8.Plug the cord into the wall outlet. Your cleaniner is ready for use.
OPERATING INSTRUCTIONS
5