Instructions

10
ENGLISH
(Original instructions)
Plunge cut saw blade for wood and
metal.
(Part number - STA26110-XJ)
Separating, plunge and ush cutting
of wood, plastics, thin-walled
non-ferrous pipes and extrusions,
nails and screws.
Plunge cut saw blade for wood
and metal.
(Part number - STA26115-XJ)
Separating, plunge and ush cutting
of wood, plastics, thin-walled
non-ferrous pipes and extrusions.
Segmented saw blade.
(Part number - STA26120-XJ)
Long life blade which is ideal for
cutting wood, plastics, thin walled
ferrous and non-ferrous material.
Rigid scraper.
(Part number - STA26135-XJ)
Ideal for removal of hard and soft
material from at surfaces such as
the removal of vinyl ooring, bonded
carpet adhesive, tile oor adhesive,
grout, paint and varnish.
Flexible scraper.
(Part number - STA26140-XJ)
Ideal for removal of elastomer
materials from hard at surfaces in
difcult to reach areas such as silicon
sealant and other caulking materials.
Carbide grout removal blade.
(Part number - STA26125-XJ)
Carbide coated surface ideal for
clearing grout and tile adhesive from
at surfaces and for fast stock
removal of wood, chipboard
and breglass.
Carbide rasp.
(Part number - STA26130-XJ)
Carbide coated surface ideal for grout
removal and for fast stock removal of
plastics, chipboard and breglass.
Sanding Sheets.
(Part number - STA32348-XJ)
Various grades for sanding of wood,
painted and varnished surfaces.
Assembly
Fitting and removing the accessories (g. G - L)
Warning! Before tting an accessory, disconnect the tool from
the mains supply/Remove battery from tool.
Fitting a STANLEY FATMAX accessory (g. G - I)
u Hold the tool and squeeze the accessory clamping
lever (3).
u Slide the accessory (10) between the shaft and the
accessory holder making sure the accessory engages all
eight pins on the holder and is ush with the shaft.
u Release the accessory clamping lever.
Note: Some accessories, such as scrapers and blades can be
mounted at an angle if required (g. I).
Removing a STANLEY FATMAX accessory
u Hold the tool and squeeze the accessory clamping
lever (3).
u Pull the accessory from the tool making sure the
accessory dis-engages from all eight pins on the holder.
u Release the accessory clamping lever.
Warning: Gloves must be worn when removing accessories
as then may become hot during use.
Fitting a sanding sheet (g. J)
u Line up the sanding sheet (11) with the sanding base (12)
as shown.
u Press the sheet rmly and evenly onto the sanding base,
making sure that the holes in the sheet coincide with the
holes in the base.
Removing a sanding sheet
u Pull the sanding sheet off the sanding base (12).
Warning! Never use the sanding base without a sanding
sheet or accessory in place.
Fitting the dust extraction adaptor (g. K)
u Line up the dust extraction adaptor (13) with the sanding
base (12) as shown.
u Press the adaptor rmly and evenly in to the
sanding base.
u Secure the adaptor by turning the locking nut
(14) clockwise.
u Connect a vacuum cleaner to the dust extraction adaptor.