Instruction Manual

ENGLISH

5. OPERATING PROCEDURE

WARNING: Always observe the safety instructions and applicable regulations.

WARNING: To reduce the risk of serious personal injury, disconnect battery pack before making any

adjustments or removing/installing attachments or accessories.

WARNING: To reduce the risk of serious personal injury, ALWAYS use proper hand position.

WARNING: To reduce the risk of serious personal injury, ALWAYS hold securely in anticipation of a

sudden reaction

5.1 PROPER HAND POSITION

Proper hand position requires one hand on the main handle (I) g. 1.

5.2 TOOL OPERATION

Installing a blind insert nut (g. 7,8,9)

Read a Touch Screen Operating Manual to know the details of how to use the touch screen.

Please visit our website http://www.stanleyengineeredfastening.com/resource-center/document-library

To install a blind insert nut

• Switch the FR lever (S) to “Stroke side” from left side to right side from the tool front. (Only rst operation)

• Pull the switch (J) once to turn on the power of the screen and to return to home.

• Adjust the stroke or force for the nut with application to be installed from the screen. (Only rst

operation)

• Push the mandrel (A) with Nut(Y) to mount the nut onto Nosepiece (B)

 *Do not put the nut onto the application before mounting it onto the Nosepieces (B)

• Position the tool and insert the tool into the hole of application (g.8)

• Pull and release the switch (J) (g. 9).

• Once the nut (Y) has been set completely, the tool returns home automatically.

Removing a nut stuck (Enforced spin o)

• Touch Enforced spin-o icon on the touch screen, it returns to home.

 OR

• Switch the FR lever (S) to “Spin-o side” from right side to left side from the tool front.

• Keep pulling the switch until a nut is removed and release the switch.

• Switch the FR lever (S) to “Stroke side” from right side to left side from the tool front for next setting.

Reset function (g.3,9)

If the tool does not move to its initial position after releasing the switch or stops during the setting stroke,

remove the battery, re-insert and then repeat the prior step, and pull the switch (J) to turn on again.

If the issue persists, contact your local service representative.