Assembly Instruction

NOTE: Your furniture may have different design features than those shown in the drawing.
95518-46 HUTCH
A-1254
4. REMOVABLE PARTITIONS
To install REMOVABLE PARTITIONS,
locate WIRE SUPPORTS in the Upper and
Lower Shelves. Align Grooves in the Top
and Bottom Edges of the PARTITIONS
with the WIRE SUPPORTS, and carefully
slide the PARTITIONS between the Upper
and Lower WIRE SUPPORTS (as shown
below).
1. LIFT HUTCH ONTO DESK:
Carefully lift the HUTCH onto the DESK
and align it.
2. ATTACH HUTCH TO DESK:
Align Back of the HUTCH with Back of the
DESK, center and secure with MENDING
PLATES and SCREWS, as shown.
NOTE: If a Power Screwdriver is used,
use a "low torque" setting.
LEVEL the DESK according to
the Instructions provided.
LEVELING:
CAREFULLY READ & UNDERSTAND
ALL INSTRUCTIONS BEFORE
PROCEEDING!
CAUTION:
(2) OR MORE PERSONS
RECOMMENDED FOR ASSEMBLY!
MENDING
PLATES
SHELF
LOWER
SUPPORTS
WIRE
SHELF
UPPER
GROOVE
REMOVABLE
PARTITION
3. ADJUSTABLE SHELVES
To remove ADJUSTABLE SHELVES,
remove SCREWS from SHELF
SUPPORTS, then carefully lift
Shelves up and out of the HUTCH.
To reposition ADJUSTABLE
SHELVES, insert Stem of SHELF
SUPPORTS into Holes as shown.
Rest the SHELF on the SHELF
SUPPORTS, and reinstall SCREWS.
SCREWDRIVER
SHELF SUPPORT
SCREW
BACK SIDE
HUTCH
BACK SIDE
DESK
110 Volt
AC Outlet
ONLY !
5. CONNECT POWER:
Plug POWER CORDS from
SWITCH into a standard
110V AC outlet ONLY.