Operation Manual
G
B
23
5.4 Fitting the air lter (ref. 1)
Remove the transportation stop with a screwdriver or 
5.5 
Replacing the oil sealing plug (ref. 14)
       
opening with a screwdriver and insert the supplied oil 
5.6 Voltage
      
         
      
5.6.1  Connection of the mains plug (electrical 
information for the BS plug)
 Important! 
●  This  product  is  double  insulated  and  therefore 
does not require a connection to earth.
●  The 3 pin plug must comply to BS1363/A.
●  Fuse must comply to BS1362.
If for any reason the 13 amp plug fitted to this product 
requires replacement  it  must  be  wired  in accordance 
with the following instruction:
Do not connect the brown (live) or blue (neutral) to 
the earth pin marked ‘E’   on the 3 pin plug.
Connect the Blue wire to the terminal marked Neutral 
        
        
by  the  cord  grip  and  that  the  wires  are  not  trapped 
If in doubt consult a qualified electrician
      
any part of the casing unless qualified to do so; this unit 
 Warning! 
For your protection if this product is to be used outdoors 
it should not be exposed to rain  or used in damp 
Note: If the mains cable requires replacing it must be 
replaced  with  an  identical  one  and  fitted  by  a 
5.7 On/Off switch (8)
5.8 Adjusting the pressure (Fig. 1)
●  You can adjust the pressure on the pressure gauge 
●      
5.9 Setting the pressure switch
5.9.1  D 210/8/6 - D 210/8/24 - D 210/8/50
:  6 bar
 
5.9.2 
D 240/10/xx - D(L) 250/10/xx - D 260/10/xx - 
DV2 400/10/xx - DV4 400/10/xx
 
:  10 bar
6. CLEANING AND MAINTENANCE
 Warning! 
Pull the power plug before doing any cleaning and 
maintenance work on the appliance.
 Warning! 
Wait until  the  compressor  has completely  cooled 
down. Risk of burns!
 Warning! 
Always depressurize the tank before carrying out 
any cleaning and maintenance work.
6.1 Cleaning
●  Keep the safety devices free of dirt and dust as far 










