Use and Care Manual

3 of 12
STANLEY is a registered trademark of The Stanley Works or its affiliates and are used under license by GXi Outdoor Power LLC.
Rev. 9/2010
Component Identification
Attaching the Chip Collection Bag
 To attach the bag, place the opening of the bag completely over the
discharge chute and hook the metal grommets on two wire hooks lo-
cated near the base of the engine.
 Tighten the draw string securely.
Recoil Starter
The starter handle is located on the engine. Pull the starter handle to start
engine.
Chipper Chute
Allow twigs and small branches up to 4” in diameter to be fed into the
impeller for chipping. See Figure 6.
Chipper Funnel
Allow leaves and small branches up to 1/4” diameter to be fed into the funnel
for chipping and shredding.
Chipper Bag (shown in hardware bag below)
Collects shredded or chipped material fed through the chipper chute or hopper
assembly.
Figure 6
Lawn Tractor or ATV Hitch
To be used for towing by lawn tractors or ATVs at speeds below 15 mph.
Discharge Chute
Chipped materials are discharged through this opening. It may be left open or
the chip collection bag (Chipper Bag) can be attached to the chute.
Fuel Tank
Fill tank with regular unleaded fuel. Always leave about 1” of air gap at the
top of the tank for fuel expansion to prevent seepage or spills.
Recoil Starter
Chipper Funnel for depositing leaves,
grass, plant debris only. Use the side
chute for branches.
Chipper Chute for feeding branches up
to 4” in diameter.
Lawn tractor or ATV trailer hitch
(maximum tow speed is 15 mph).
Discharge
Chute
Fuel Tank
Hardware bag, safety devices
and chip collection bag
Clean out and blade
access hatch
Serial #:
Stamped on engine block between funnel
and engine
Red Electric Start Push Button
120V Outdoor Extension Cord
Connection (Plug in for 120V
electric start)