Use and Care Manual

10 of 12
STANLEY is a registered trademark of The Stanley Works or its affiliates and are used under license by GXi Outdoor Power LLC.
Rev. 9/2010
To Remove, Sharpen or Add Chipper
Blades:
Your chipper was sent with one blade attached and a spare blade in the hard-
ware bag. The belt life will be extended by operating the chipper with a sharp
blade at a time.
 Disconnect the spark plug wire and ground against the engine.
 Remove the blade access hatch and rotate the blade to align with the
access hatch.
 Remove the flail screen in the discharge chute by removing the pins that
secure it at the top and bottom of the screen.
 Remove the blade using a 3/16” allen wrench on the outside of the
blade and an adjustable wrench on the impeller assembly (through the
discharge chute). A piece of pipe or wood should be used to block the
flails, preventing them from inadvertently turning.
 Add, replace or sharpen the blades as desired.
 When sharpening the blade, protect hands by using gloves and follow
the original angle of grind. Also, make sure to remove an equal amount
from each blade and torque to 250 - 300 in. lbs.
NOTE:
Make certain blades are reassembled with the sharp edge facing
upward.
Maintenance & Storage