Installation Sheet

ManualsBrandsSTANLEY ManualsHardwareBF50-41 2C HANGER # 40-2303

STEP 4 - Install hinges.

STEP 8 - Press snugger into

track between sets of doors

(or door and jamb in 2 Dr.

installation). Snugger is self-

centering along track.

Step 8 continued on next page

2 OR 4 DOOR INSTALLATIONS - continued

STEP 7 - TO ADJUST DOORS HORIZONTALLY - with wrench

provided, loosen hex head screw on jamb bracket, or top

pivot bracket as required. TO ADJUST VERTICALLY - place

large end of wrench on bottom pivot hex nut and make a

series of short ratchet-like turns. (Min. clearance between

top of door and track is

/4".) Finally, adjust hanger bolt for

smooth, even “ride” in track.

STEP 6 - Attach jamb pivot

bracket to center line of pivot

hole is plumb with center line

of track. Bottom leg should

rest firmly on carpet or floor.

(Hole is provided for mounting

to floor if desired.)

STEP 5 - Trim track to exact

length of finished opening,

and screw track to header.

Loosen top pivot bracket to

adjust, making certain hex

screw is closest to jamb.

STEP 8 - Lift door with pivot into position by inserting spring-

loaded pivot pin into top pivot bracket. Push door upward

(compressing pin), then drop bottom pivot into jamb bracket

hole. With other doors, enter hangers on track where ridges

are notched out. Slide doors together and reassemble

hinges by replacing pins.

STEP 7 - Attach jamb pivot bracket (same as Step 6, left

hand column).

ACCORDION DOOR INSTALLATIONS - continued

STEP 4 - Install mortise

hinges with knuckles alter-

nately at front and rear of

doors, then separate hinges

by pulling pins. Keep knuckles

close to door edge.

STEP 5 - Trim track (same as Step 5, left hand column).

STEP 6 - With edge hung

doors, when locating close to

a wall, drop ceiling, post, etc.,

minimum clearance to track

should be (X); thickness of

door plus 1".

KNUCKLE

(X)

HANGER

BOLT

HEX HEAD

SCREW

BOTTOM

PIVOT

BOLT

HEX HEAD

SCREW

BOTTOM

PIVOT

JAMB PIVOT

BRACKET

JAMB

HEADER

TOP

PIVOT

TOP PIVOT

PLATE

TRACK

HANGER

HINGES WITH

PINS REMOVED

A - Find cut-outs in track.

B - Rotate hanger to fit

wheels in track from below

the cut-outs.

C - Rotate hanger to align

wheels to track.

D - Adjust so spring slightly

compresses.

STEP 8 (expanded) -

HANGER

SPRING DETAIL