Instruction Manual
SYMPTOM POSSIBLE CAUSE REMEDY PAGE REF.
Trigger inoperative Static friction Depress trigger a few times
Low air pressure Increase air pressure
Valve piston remains stuck
Depress trigger several times. Lubricate
tool through air inlet. If unsuccessful,
dismantle, clean and lubricate trigger
elements
Drive screw does not
return and/or keeps
spinning o
Lip seal 18 is defective Replace 17
Tool does not spin o Adaptornut 92 loose Tighten
No air supply Connect
Rear casing unscrewed by more than
5 turns
Set tool stroke 5 turns
‘O’ring 82 leaking air Replace 18
Distributor stuck Lubricate
Air motor jammed
Lubricate tool at air inlet. If insucient
dismantle and clean air motor thoroughly
Item numbers in bold refer to general assembly drawings and parts list (pages 18-19).
Other symptoms or failures should be reported to your local Stanley Engineered Fastening authorised distributor or repair
centre.
22
ENGLISH ORIGINAL INSTRUCTION