Instruction Manual

6. SERVICING THE TOOL

Regular servicing should be carried out and a comprehensive inspection performed annually or every 500,000 cycles,

whichever is sooner.

CAUTION: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals

may weaken the materials used in these parts.

CAUTION: Before maintenance, remove any dangerous substances that may have accumulated due to work processes.

CAUTION: The employer is responsible for ensuring that tool maintenance instructions are given to the appropriate

personnel.

CAUTION: The operator should not be involved in maintenance or repair of the tool unless properly trained.

CAUTION: The tool shall be examined regularly for damage and malfunction.

CAUTION: Read Safety Instructions on page 4 to 6.

6.1 DAILY SERVICING

• Daily, before use or when rst putting the tool into service, pour a few drops of clean, light lubricating oil into the

air inlet of the tool if no lubricator is tted on air supply. If the tool is in continuous use, the air hose should be

disconnected from the main air supply and the tool lubricated every two to three hours.

• Check for air leaks. If damaged, hoses and couplings should be replaced by new items.

• If there is no lter on the pressure regulator, bleed the air line to clear it of accumulated dirt or water before connecting

air hose to tool.

• Check that the nose assembly is correct.

• Check the stroke of the tool is adequate to place selected insert. (See stroke adjustment page 9).

• Inspect the drive screw in the nose assembly for wear or damage. If any, renew.

6.2 WEEKLY SERVICING

* Check for oil leaks and air leaks on air supply hose and ttings.

6.3 SERVICE KIT

For all servicing we recommend the use of the service kit (part number 74200-99990) supplied in its own plastic case.

SERVICE KIT 74200-99990

Part Number Description QTY Part Number Description QTY

07900-00618 PUSHER 1 07900-00393 14mm/15mm SPANNER 1

07900-00619 GUIDE BUSH 1 07900-00409 12mm/13mm SPANNER 1

07900-00478 Ø 3mm PIN PUNCH 1 07900-00626 11mm SPANNER 1

07900-00624 Ø 4mm PIN PUNCH 1 07900-00469 2.5mm ALLEN KEY 1

07900-00157 INTERNAL CIRCLIP PLIERS 1 07900-00351 3mm ALLEN KEY 1

07900-00161 EXTERNAL CIRCLIP PLIERS 1 07900-00224 4mm ALLEN KEY 1

07900-00625 SOFT MALLET 1 07900-00225 5mm ALLEN KEY 1

07900-00623 25mm SOCKET 1 07900-00620 12mm ALLEN KEY 1

07900-00006 SPATULA 1 07900-00456 T BAR 1

07900-00434 32mm SPANNER 1 07992-00075 MOLYKOTE 55M (100 gm TUBE) 1

07900-00621 28mm SPANNER 1 07900-00627 PLASTIC CASE 1

07900-00637 17mm SPANNER 1 07900-00632 17mm/19mm SPANNER 1

07900-00643 PUSHER KNOB 1

ORIGINAL INSTRUCTION ENGLISH