User's Manual

USER’S GUIDE- 23
WIRELESS ACCESS MANAGEMENT SYSTEM
Programmer
Programmers can scan all channels at the keypad reader as well as reset the reader to respond
to keypad commands as in manager mode. The programmer must enter his or her specific
programmer code then:
Press #7 to scan all channels
Or
Press #8 to use manager codes.
NOTE: Managers and programmers are indistinguishable from a general user when no keyboard
is present.
Reader Control
The system defaults the amount of time from the moment a reader unlocks until it relocks, and
the amount of time a door can stay open before an alarm will be triggered. You can modify
reader operate and shunt times for individual users. For example, to be ADA compliant, a user
who is in a wheelchair, or uses a walker may need more time to pass through a door. You can
increase the shunt time for this user.
To modify reader operate time:
In the Reader Control category, Operate Time, select the amount of time you wish to
leave the reader in the unlocked position from the drop-down list.
To modify reader shunt time:
In the Reader Control category, Shunt Time, select the amount of time you wish to allow
for passage before an alarm will be triggered.