User Manual

Add and Conﬁgure Portal Gateways (Task 7)

Portal Gateways can now be added and conﬁgured within the software. Portals

are conﬁgured from the factory with an IP address of 192.168.1.200. When conﬁg-

uring a Portal Gateway, it is best to connect directly to the Portal before placing

it on the network. This removes the possibility of duplicate IP addresses on the

network.

You can change the IP address of your Portals with the Portal Conﬁguration Mod-

ule.

Note All Portal Gateway IP address must be unique across the entire system.

Conﬁguring a Portal Gateway with the Portal Conﬁguration Module

Perform the following steps to change your Portal Gateway’s IP address.

1 Connect the Portal Gateway to the Host either over the network or directly via

crossover Ethernet cable (recommended). For more information on connecting

a Portal Gateway, see “Connecting the Portal Gateway and Verifying Opera-

tion” on page 24.

2 Open the Portal Conﬁguration module (Start Menu>Stanley Security Solutions>Stanley

Wi-Q AMS Tools).

3 Portals available on the network will automatically be listed in the Portal Con-

ﬁguration module.

Figure 42 Portal Gateways Available on the Network