User Manual

Check Controller Operation

Verify controller operation using the steps appropriate for your controller type

(Magnetic Card or keypad). If the system does not operate properly, see Trouble-

shooting, at the end of the section.

Magnetic Card Check

If your system has a magnetic card controller (mag card), default Programmer

ID cards are supplied with the software. You will need these cards when you are

ready to sign on the controllers.

To perform a magnetic stripe card veriﬁcation:

1 Determine if the magnetic card type is Track 2 or Track 3.

2 Select the default Programmer ID card that matches the type for your magnetic

card controller.

3 Insert and remove the magnetic card. The magnetic stripe on the card should

be aligned with the ‘V’ mark by the card slot. The lights on the top of the Con-

troller will ﬂash green once and unlock, then during the open delay time, it will

ﬂash green ﬁve times. Once this occurs, the card controller light will ﬂash red

and lock.

4 While unlocked, check for proper lock operation.

Keypad Check

If your Controller is a keypad type, perform the following steps:

1 At the keypad, enter the default Programmer ID, 1234#. The green light on top

of the card controller will ﬂash once and the lock will unlock, then during the

open delay time, it will ﬂash green ﬁve times. Once this occurs, the controller

red light will ﬂash and the lock will relock.

2 While unlocked, check for proper lock operation.