User Manual

Installation Instructions for Stanley Omnilock 9KOM Cylindrical Locks
Stanley Omnilock
a Product Group of Stanley Security Solutions, Inc.
4
Preparing the door and door jamb
Use drill jig to drill through-bolt holes
1 Press the drill jig (KD303) onto the door, engaging
it with the latch tube prongs (see the close-up in
Figure 5). Make sure the front edge of the jig is
parallel with the door edge.
2 Drill the through-bolt holes (5/16(8 mm)
diameter) halfway into the door.
3 Turn over the drill jig and repeat steps 1 and 2
from the opposite side of the door.
Note 2: Replace the drill jig after 10 door
preparations.
Figure 5 Installing the drill jig and drilling the
through-bolt holes
Latch
tube
prong
Drill upper through-bolt hole.
Drill lower through-bolt hole.
Inside of door