User Manual

Manufacturer Part number
Stanley 909028065
Indala FP2511A
XceedID XF-1050-B
HID 5355AGK00
Essex KTP-163-SN
Installation Instructions for Stanley Wi-Q™ Technology WQX-WAC Wireless Access Controllers
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
2
Planning the installation
■ Sensors: door, latch, deadbolt, key, and/or other.
Note: Some sensors may be included inside the lock.
The BEST 45HW may include door, latch, deadbolt,
and key sensors.
3 Pull wire and make connections to
wireless access controller
1 Determine what connections you need to make
based on your application.
2 Using Figure 2 and Table 1 make the connections.
Table 1 WAC Connections and descriptions
Terminal Description
Strike NC
Normally-closed terminal
where the locking mechanism
connects
Strike COM
Common return path for cur-
rent through the locking mech-
anism
Strike NO
Normally-open terminal where
the locking mechanism con-
nects
SHUNT NC
Normally-closed relay terminal
that shunts door force alarm if
access is granted or RQE is acti-
vated
SHUNT COM
Return path for the shunt relay
SHUNT NO
Normally-open terminal for the
shunt relay
KEY
Detects and reports a key-over-
ride event
GND
Return path for the key-over-
ride switch and RQE
RQE
Request-to-exit input
DS
Door status input
GND
Return path for door status and
latch status
LS
Latch status input
WIEGAND 0
Wiegand D0 terminal
GND
Ground (the wiegand reader
must be grounded at this
point)
WIEGAND1
Wiegand D1 terminal
RED
Red LED control input
GND
LED ground point
GRN
Green LED control input
ANT
Antenna connection
Negative DC
terminal
Power connection
Negative DC
terminal
Power connection. Use the
extra negative DC terminal to
‘daisy-chain’ power to another
wireless access controller or
reader.
a
a. Make sure the power supply is of appropriate
wattage to supply enough power.
Positive DC 9–24V
terminal
Power connection
Positive DC 9–24V
terminal
Power connection. Use the
extra positive DC terminal to
‘daisy-chain’ power to another
wireless access controller or
reader.
a
Important note: When using the WAC to daisy-chain
other devices, be sure that the other devices will
accept the voltage supplied to the WAC.
Table 1 WAC Connections and descriptions
Terminal Description