User Manual

1
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
Introduction
The WQX Wireless Access Controller (WAC) controls
access to one door or access point. It runs on four AA
batteries, or can be externally powered with a DC
power supply. The WAC can be purchased integrated
in a box with power supply or can be purchased stand-
alone. If purchased as a stand-alone unit the power
supply powering the WAC (WQX alone with no other
devices connected) must be able to deliver at least
500mA.
Figure 1 Wireless Access Controller, shown without
cover
Antenna
Mounting hole
Terminals
Four AA
Batteries
Power terminal
Mounting hole
a
Site survey
If a site survey has not been completed, contact your
Stanley Representative.
Components checklist
Use the following checklist to make sure that you have
the items necessary to install your Wireless Access Con-
troller.
a. Power for WAC device only. Calculate power
requirements for attached readers separately.
Components provided in the box
❑ Wireless Access Controller with antenna
❑ Batteries
❑ Documentation
Optional components
❑ Indoor ceiling mount omni-directional antenna
❑ Indoor wall mount directional antenna
❑ Outdoor mount directional antenna
❑ Outdoor mount omni-directional antenna
❑ Enclosure
1 Mount Wireless Access Controller
The standard WAC comes with a small antenna, but
you may need a supplemental antenna for your appli-
cation. See the Site Survey Tool Quick Reference Guide
for more antenna information.
1 Determine the appropriate location for the wireless
single door controller, making sure that the
antenna will have maximum exposure for signal
transmission.
2 Mount the Wireless Access Controller box.
3 Screw on antenna as shown in Figure 1 so that it’s
vertical and upright.
4 Install batteries if needed.
2 Install other hardware as necessary
Make sure all other system components are mounted
and installed. System components may include:
■ Electronic or electric lock or strike
■ Request-to-exit switch
■ Power supply for lock or strike
■ Reader: either magstripe, proximity, keypad or com-
bination readers. The default reader is a Weigand,
26-bit, 8-bit word type.
Installation Instructions for
Stanley Wi-Q™ Technology
WQX-WAC Wireless Access Controllers