User Manual

Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
19
Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
Completing the installation
19 Install battery/antenna cover
1 If installing with a surface vertical rod exit device,
carefully use a razor blade to remove the knockouts for
the rod from the battery cover. See Figure 30.
2 Connect the antenna to its mating connector.
3 Coil the antenna wire carefully inside the battery
cover.
Caution: Carefully bend, but do not twist or kink
the antenna wire. Doing so may significantly
reduce or completely interrupt signal transmis-
sion.
4 Making sure that the battery/antenna cover does
not pinch any wires, place the battery/antenna cover
over the bracket and battery.
5 Secure the battery cover with the provided self-tap-
ping screws.
Caution: Tighten screws firmly but do not over-
tighten. Over-tightening may strip screw holes or
crack the cover.
Figure 30 Installing the battery cover over the battery
bracket and connecting the antenna
Battery/
antenna cover
Antenna wire
Battery bracket
Carefully bend,
but DO NOT
TWIST OR KINK
the antenna
wire!
Knockout