User Manual

Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
15
Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
Installing the exit hardware and trim
5 Make sure to route and dress the wires so that they do
not interfere with any moving parts.
6 Tape the wires to the device head (some tape is pro-
vided).
Note: For Precision 2200, 2700, and 2800 exit devices,
use cable ties in addition to the tape, to hold wires as
shown in Figure 26.
7 Install the case cover.
Org
NC
Blue
Tan
COM
Red
Wht Wht
Wht Wht
Red
Blue
Touchbar
switch
EXQ Trim
Door
position
switch
NO
Yellow
Not used
Figure 25 Schematic diagram for connecting Von Duprin
sensor harness wires
Butt
splices
Sensor
harness
Not used
}
NO = Normally Open
NC = Normally Closed
COM = Common
TOP
Figure 26 Using cable ties to hold wires for Precision
2200, 2700, and 2800 exit devices
Use cable tie
here to secure
the sensor
harness
Sensor har-
ness coming
thru the 5/16”
hole
described in
Figure 17
Cable tie