User Manual

Installation Instructions for Wi-Q Technology™ EXQ Exit Hardware Trim
2
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
❑ Battery bracket
❑ Door position
switch with
magnet
❑ Battery cover with
antenna
❑ Battery pack
❑ Battery cover screw
package
❑ Bar code ID sticker
(for your records)
❑ Cable ties, butt-
splices, and tape
❑ Installation
templates and
instructions
BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
1
Introduction
These installation instructions describe how to install your
BEST® Wi-Q Technology™ EXQ Series Exit Hardware Trim.
Electronic Stand-Alone Exit Hardware Trim is available for
use with the following types of wide stile exit devices
manufactured by Stanley-Precision Hardware (2000
Series) and VonDuprin® (98/99 Serie s):
Not all features are available for all exit device configura-
tions. The table below details what sensors are available
for which exit device configurations:
n
Contents
These instructions cover the following topics:
Planning the installation................................................1
Preparing the door........................ .................................. 4
Installing the exit hardware and trim............................8
Completing the installation..........................................15
Device
DS
a
a. Door position sensing
TS
b
b. Request-to-ex
it (PHI touchbar monitoring)
LS
c
c. Latc
h sensing
Precision
Rim (2100)
Surface Vertical (2200)
Mortise (2300)
Wood Door Concealed (2700)
Concealed Vertical (2800)
Von Duprin
Rim
Surface Vertical
Concealed Vertical
Site survey
Use the following survey to record information about the
installation site and hardware application.
Exit hardware type:
Door handing and bevel:
Left-hand reverse bevel (LHRB)
Right-hand reverse bevel (RHRB)
Door type:
Door thickness: inches (1-3/4″ to 2-1/4″ )
Compone
nts che
cklist
Use the following checklist to make sure that you have the
items necessary to install your EXQ Exit Hardware Trim.
rim surface vertical rod
mortise concealed vertical rod
Wood Metal
Escutcheon and
lever assembly
Battery bracket
Installation Instructions for
Wi-Q Technology™ EXQ
Exit Hardware Trim
Tools required
Use the following checklist to make sure that you have the
tools necessary to install your EXQ Exit Hardware Trim.
For Precision® Hardware and Sargent installations
❑ 1-3/8” dia hole saw (EV function only)
❑ 1-1/8” dia hole saw
For Von Duprin® installations
❑ 2” dia hole saw
❑ 3/4” dia hole saw
For BEST® cylinders
❑ BEST ED211 cylinder wrench
For surface vertical exit devices
❑ Razor blade
❑ 7-pin core (only
included if ordered
with trim)
❑ Cylinder mounting
sleeve (for Von
Duprin functions
only)
❑ Temporary
operator card
❑ Key cylinder and
keys (only included
if ordered with
trim).
❑ Electric drill (preferably corded) ❑ Straight edge
❑ Jigsaw ❑ Square
❑ Wire snips ❑ Pencil/marker
❑ Wire strippers ❑ 7/16” dia drill bit
❑ Phillips screwdriver ❑ 7/8” dia drill bit
❑ Measuring tape ❑ 1” dia hole saw
BEST
Temporary
Operator
Rim cylinder Mortise cylinder
OR