User Manual

BEST ACCESS SYSTEMS
a Product Group of Stanley Security Solutions, Inc.
1
Introduction
These installation instructions describe how to install your
BEST® Wi-Q Technology™ EXQ Series Exit Hardware Trim.
Electronic Stand-Alone Exit Hardware Trim is available for
use with the following types of wide stile exit devices:
Precision® brand manufactured by Stanley (2000 Series),
Von Duprin® (98/99 Series), and Sargent® (8800 Series).
Not all features are available for all exit device configura-
tions. The table below details what sensors are available
for which exit device configurations:
n
Device
DS
a
a. Door position sensing
TS
b
b. Request-to-exit (PHI touchbar monitoring)
LS
c
c. Latch sensing
Precision
Rim (2100)
■ ■ ■
Surface Vertical (2200)
■ ■ ■
Mortise (2300)
■
Wood Door Concealed (2700)
■ ■ ■
Concealed Vertical (2800)
■ ■ ■
Von Duprin
d
d. Von Duprin is a registered trademark of Von Duprin, Inc.
Rim
■ ■
Surface Vertical
■
Concealed Vertical
■
Sargent
e
e. Sargent is a registered trademark of Sargent Mfg. Co.
Rim
f
f. Latch must have lift-type trim input (8863)
■
Contents
These instructions cover the following topics:
Planning the installation................................................ 1
Preparing the door.......................................................... 3
Installing the exit hardware and trim ........................... 7
Completing the installation ......................................... 16
Site survey
Use the following survey to record information about the
installation site and hardware application.
Exit hardware type:
Door handing and bevel:
❑ Left-hand reverse bevel (LHRB)
❑ Right-hand reverse bevel (RHRB)
Door type:
Door thickness:
inches (1-3/4″ to 2-1/4″)
Components checklist
Use the following checklist to make sure that you have the
items necessary to install your EXQ Exit Hardware Trim.
❑ rim ❑ surface vertical rod
❑ mortise ❑ concealed vertical rod
❑ Wood ❑ Metal
❑ Escutcheon and
lever assembly
Installation Instructions for
Wi-Q Technology™ EXQ
Exit Hardware Trim